Vitec is a competent partner for all industry-specific areas of application in cleanroom technology, life science, healthcare and industry.

Modular prefabricated cleanrooms for up to 300 m² and up to cleanroom classes ISO 3, ISO 5 and ISO 7.

Cost-effective and time-saving alternative to a conventional new building or the costly renovation of an existing building.

THREE PRE-ENGINEERED STANDARD CLEANROOM SOLUTIONS TO CHOOSE FROM:

• Vitec – Nano
• Vitec – Pure
• Vitec – Vivo

Modular cleanroom wall system with visible substructure made of system profiles (anodized aluminum or powder-coated, alternatively stainless steel) and flush panels made of sheet steel, stainless steel, aluminum composite panels or glass.

The shells, which are edged on all sides, are fastened to the system profiles by means of tongue-and-groove battens.
For the glazing, insulating glass compact panes or industrially prefabricated spring frames for single-sided glazing are available.

The system can be sealed both permanently elastic and dry and withstands negative or positive pressure up to 300 Pa.

The design features comply with DIN 14644-4 and VDI 2083.

The wall elements are supplied as prefabricated axle-width individual elements with finished surface and are assembled on site to form partition wall units on site.

The individual elements are interchangeable without dismantling neighboring elements. The exchange of wall elements for door elements (and vice versa) is possible. All elements can be moved and replaced without any changes to the construction, without The elements
can be easily and uncomplicatedly replaced without any changes to the construction, without reworking and without additional material, and with little expenditure of time - even by non-experts - and without special tools. The elements are still usable even after multiple conversions.

The connection of the elements among themselves is done by a simple system. The creation of T, corner, Y and cross points in 2, 3 or 4 directions is possible. 90° corner points as integrated edge protection made of approx. 2 mm stainless steel are available.

All connections to the structure are sealed with elastic sealing materials. The wall elements can be assembled and disassembled can be assembled and disassembled individually without affecting the ceiling.

The infill panels are pre assembled at the factory so that they only need to be installed in the substructure on site. There are no visible screw connections on the wall surfaces.

By fixing the partitions, no vertical clamping pressure is exerted against the ceilings or partitions. Connections in the facade area, on the masonry and on the building supports run in a straight line, unless otherwise specified in the specifications. A high degree of stiffness of the partition walls against deflection and lateral deflection when the walls are loaded by air pressure, shelving, cabinets, sinks, apparatus, etc., is guaranteed. Walls and ceilings are able to withstand an overpressure or underpressure (in case of ventilation system failure) of up to 200 Pa without permanent damage.

Electrical cables can be installed horizontally and vertically in the entire wall area at any time, even as a retrofit, without impairing the sound insulation. in the entire wall area without impairing the sound insulation. Commercially available windproof flush-mounted light switches and sockets can be installed. is guaranteed. Inlets and outlets for washbasins, wall-mounted laboratory equipment, etc., can be integrated in the wall up to a diameter of 50 mm. can be integrated into the wall. Appropriate reinforcements are offered if necessary.

The entire wall cavity of solid wall elements is accessible for this work from any side of the wall, the opposite side remains closed. side remains closed.